The SE3-320 Noise Processor includes standard 4-20mA Current Loop outputs. These provides a signal that does not degrade due to resistance, allowing for longer cable runs, limited by the ability to drive the current.
There are two current loop outputs on the SE3-320, so you can select two different parameters to monitor. Both outputs are set to the same measurement range, but you can select different parameters, as described below.
Each current loop output can be one of the following noise measurement parameters:
The overall measurement range of the SE3-320 is 30dB to 120dB. You can process this whole range over the current loop output, or you can select the range of interest.
In the example above, the first output is the average sound level every second (probably the most useful parameter available) while the second output is the average over a 15 minute period. A sound level of 50dB will be the minimum (4mA) and a sound level of 90dB will be the maximum (20mA).
The SE3-320 comes with two powering options: USB (5V) or 24VDC. When using the current loop output the unit must be powered by 24VDC, it will not work with the USB option. For convenience, the 24VDC power connections are on the same connector as the current loop outputs and ground.
At the rear of the noise processor there is a connector block - the green part on the image. This connector pulls out of its socket and contains screw terminals to connect the following: